Features of the 1200 Super S
 
 
 
DVM 
    An 800 Mhz Power Meter Option, DBm SCALE and DBm Referencing
      mode have been added to the DVM Function.
 
RCC
    .10PS, 20PS, MTS and IMTS Have been combined in a new function called RCC.

OFFSET 
   The Duplex offset can now be adjusted from 0 to +/- 49.9975 Mhz in 2.5 Khz steps
 
PAGING
   2-Tone and 5/6 Tone Sequence (Encode Only) Are now much easier to program
   and execute.
 
DCS
   The DCS Function was modified to automatically change from Encode  (GEN) to Decode
   (Rec) when the T/R ports XMIT - Detection line goes high. The Mode switch must be in
   Gen to enable this function.

RF FREQUENCY ERROR METER
   The RF Frequency Error meters resolution was changed to reflect the actual resolution of
    the hardware. The Meter was also modified to flash the the meter is over-ranged. 

AUDIO FILTER
  A programmable audio filter has been added to the 1200 Super S. The filter can be
   configured as a preset speech bandpass filter or a user-programmed highpass, lowpass,
    bandpass or notch filter. The demod routing can also be user defined.
  
LTR OPTION
   Several Changes to the LTR Option were added.
   1. Several Function Labels in the LTR Programming screens have been changed to
        provide a more User-Friendly Setup.
   2.  A Handshake ID Field has been added which is used during the repeater auto tests.
   3.  The number of trunking channels have been added to 760
   4.  A repeater RIC (Interconnect) test and LTR Generate test have been added.
 
CELLULAR OPTION
    The programming Field for printer baud rate has been changed to  indicate the actual
      baud rate rather than a "magic" number.
 
DTMF
    The 1200 Super S DTMF Decode function can store up to 64 characters

TONE
     A TTL waveshape has been added to the tone function.
  
TRACKING GENERATOR OPTION
    A cable fault function has been added to the optional tracking generator.
 
   EUROPEAN SIGNALING OPTION
   A continuous and a one-shot mode have been added to the european signaling option.

CTCSS
   A CTSS Encode/Decode Function has been added which makes it much easier and
   faster to decode sub-audible tone. Note that option 11 is required to take full advantage
   of the improved encode function.

CHANNEL MODE
    A channel mode has been added which allows the user to set the instruments RF
    frequency by selecting channel numbers for cellular, trunking, cordless phones, TV (Cable),
   And Citizen Band. In addition, a user mode is available which can store up to 99 frequencies.

SET UP
    A new setup mode has been added. This function contains various setup screens.
    1. VFD Intensity
    2. RS-232 Configuration
    3. Tone Sequence
    4. Scan
    5. Deviation Check
    6. Harmonic Check
    7. European Signaling Configuration

MEMORY
   The memory function has been enhanced so that both a Generate and Receive Frequency
   can be associated with one memory location as well as a DCS Code, CTCSS Tone or any
   other audio tone.

RS-232
    Many new RS-232 Commands have been added to support the new features added to the
   1200 Super S.